|Date Added:||4 October 2016|
|File Size:||59.41 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Thanks in advance for any assistance. Mentions Tags More Cancel. Is there something else that I need to set? The source code window, the disassembly window, the register window, and the call stack window of the C-SPY debugger are task sensitive.
Exceptions in the Interrupt log and Timeline window are now named correctly when ETM trace is enabled. Only a few pins needed for SWD to work yet does not work.
Plug-In for IAR Embedded Workbench
The selected task will be highlighted in yellow and the call stack and preserved general-purpose registers of the suspended task are rebuilt. In some cases, when using jlinnk features, executing an application in the debugger over a long time no iaar results in a Runtime Error! No license, either express or implied, by estoppel or otherwise, is granted by TI. It will list the cpu and connect if the interface, clock, license, etc are ok. J-Flash is the software component needed for stand-alone flashing support: I am also not very familiar with the J-Link Commander, iaf maybe I could help a bit.
I then configure the device to be a Cortex M4 instead of the device name as it is absent from list and compile with no errors.
embedded – Writing IAR output to ARM chips without IAR – Stack Overflow
They are somewhat expensive for an existing J-Link. C-SPY no longer terminates unexpectedly when stopping on a breakpoint that executes a macro that removes breakpoints. If you have further questions related to this thread, you may click “Ask a related question” below. I cannot connect to the module. By default, the selected task is the running task, which is jlikn usual behavior that the user expects from a debugger.
In addition, it is available in the The debugger might close unexpectedly when reading from a non-existent peripheral location.
If there is only SWD, it should just connect. New reset methods added. Nov 14, 6: Vector catch functionallity did not work properly and in some cases this could lead to the fact that two breakpoints were set at same address.
Diagnostic jlunk sent from the J-Link driver during download were incorrectly treated as warnings. The diagnostic message “Debugger problem discovered: For some JTAG or target errors the debugger could hang forever waiting on execution to stop. Then try reading a register, etc. Support for the Synergy S3A6 devices was added in V6.
Firmware flashing with IAR on FRDM board
It is reporting V4. When using the Attach to program option and having the stack plugin enabled, the debugger crashed when ending a debug session. Thanks for comments and jkink. This enables you to inspect the state of several embOS primitives such as the task list, semaphores, mailboxes, and software timers. Some CPUs do not emit any trace information for certain instructions during single step due to a bug in the silicon.