Learn More About RoadReady. Try to remove the video card by holding it perfectly horizontal. Now we are through to the motherboard and are almost ready to assemble a new GeForce Go GTX graphics card with dual heat pipe. You can put it turned upside down on the touchpad. Before removing the CPU, one needs to twist the screw on the Socket clockwise with a screwdriver. As you might guess, it had quite an impact on the video cards temperature emissions, which varied between degrees Celsius, with the fan turning on sporadically. In order to disconnect it, one has to grasp the blue tape and pull the connector upwards.
|Date Added:||12 July 2011|
|File Size:||28.46 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Moving it gently, try to arrange the card ideally, screw counter-clockwise and press it vido the motherboard. After fixing all the parts of the cooling system, you are about to set up the top case and mount the display.
Let’s start by cleaning both fans. Be careful not to pull the whole thing out of the printed circuit board PCB.
Unscrew the screws starting at the upside of the base unit marked with small red circles and those at the bottom of the base unit. The final result looks like this: Dismantling the video card manual from the Dell’s website: First of all we are obliged to warn the Reader, that all attempts to disassemble a notebook result in loosing guarantee rights and are, therefore, performed at own risk and responsibility.
Learn More About RoadReady. Finally, you’re now inside and can disassemble everything you wish. However, there are some exceptions, e.
Case Study: Replacing the Video Card of a Dell Inspiron E1705 (9400)
In order to disconnect it, one has to grasp the blue tape and pull the connector upwards. After installing the MobileForce It is yet a long way to be able to access it It is affixed at its upper part by two screws.
Don’t forget to reconnect the power switch, the touch pad, and the BIOS battery. You’ll notice, when the card is in its place. Finally, the e175 including the power switch has to be put on the top cover. Warranty and Support Services. Removing the hard disk Dell’s official manual: Do not pull the grey joint, as it is soldered to the printed circuit board PCB.
Dell Inspiron E Video Card | eBay
Before removing the CPU, one needs to twist the screw on the Socket clockwise with a screwdriver. First, I had to check, if the left heat pipe GTX would fit into the case.
In our case one has to disconnect pins No. The standard clocks for the GTX card: Hence, one should blow those away with compressed air. After unscrewing them, you put the upper part of the keyboard upwards and then pull it out in the direction of the screen.
There are no more surprises awaiting you here, the whole thing comes off easily. The left hinge has a small extension, which fits into the case. Unfortunately, there is no immediate access to them, so every time you’d like to clean them, you have to take the laptop into pieces.
They don’t interfere with one another in any way. The connector of the power switch and e17005 indicator lights, and the connector of the BIOS battery: You have to remember that you should viceo the WLAN cables onto the other side of the case and connect them in a proper way the white one – 1; the black one – 2 with the module.
The bottom memory sticks are cooled by a thin sheet of metal. Further details about dismantling the keyboard can be found at Dell’s website: Now, you should disconnect three connectors of the motherboard see the last picture: