When the incoming frame is larger, the skbuff is passed directly up the protocol stack. Linux – Networking This forum is for any issue related to networks or networking. The time now is If you type “dmesg less” and using the arrow keys scroll down looking for “no known interrupt for pin X of device X”, those are not good. Some interesting information, though I don’t know if this has anything to do with it, the network config shows the drivers to be natsemi DP 5 yet the chip on the card is DP 6. Yeah IP’s are set correctly.. Is there something specific that I should be looking for?

Uploader: Tygohn
Date Added: 5 September 2008
File Size: 59.10 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 87464
Price: Free* [*Free Regsitration Required]

Netgear FA and RedHat 9.

IgH EtherCAT Master for Linux

Check this out – http: The original author may be reached as becker scyld. I have just been told by a work mate that these cards just simply wont work with linux. Unlike software-only systems, device drivers interact with complex hardware.

I’ll also see what the netgear people say when I send them back 16 network cards linuz.

IgH EtherCAT Master for Linux

It’s not so much about the brand-name, or lack thereof, it’s mostly about the chipset on the card. Open Source Consulting Domain Registration. There should only be one module associated with the netcard, so the modinfo command would be “modinfo modulename” where the “modulename” is dp8386 likely what comes after “alias eth Does anyone know how I can fix this?!?!


The netgear drivers made no difference, while the scyld drivers dp8381 the error message to ‘Something Wicked Happened!

Yeah IP’s are set correctly. They say we only want to do this for rev C of the chip, but engineers at NSC Bradley Kennedy recommends always setting them. I am currently at work, I will give you the output from ‘route’ and those other commands in a few hours when I get home. Click Here to receive this Complete Guide absolutely free. Copying also preloads the cache, which is most useful with small frames.

Find More Posts by Ed G. Yeah a few searches I did were in google, eth0: It said on the Netgear site that they are supported in RedHat To me, realtek works and works best, for the money. Unknown Device f Flags: Ok after blind login and network service stop I got this – Route – Showed nothing other than the headings No ip’s nothing lspci -v – A subtle aspect of the operation is that unaligned buffers are not permitted by the hardware.


By joining our community you will have the ability to post topics, receive our newsletter, use the advanced search, subscribe to threads and access many other special features.

I have tried other slots, with both cards, I have also tried just running one card, same problem.

Review your favorite Linux distribution. Ignore the second half. One each both natsemi. You should see the same module name turn up when you do “lsmod”, which shows a list of all currently loaded modules. These may be modified when a driver module is loaded.

Note that registered members see fewer ads, and ContentLink is completely disabled once you log in. Media selection timer tick. If only I didnt buy so many of the fn lknux This file is not a complete program and may only be used when the entire operating system is licensed under the GPL.

There are no ill effects from too-large receive rings.

Author: admin